System Shutdown - Avaya 9600 Series User Manual

20.6 System Shutdown

You can shutdown the telephone system for a specified number of minutes. Note that this is not a polite shut-down, once
you have confirmed the action, any existing calls and services using the IP Office telephone system will start being
disconnected. The telephone system will then remain unavailable for the duration you specify, the default being 10
minutes. After the shutdown duration it will take up to 5 more minutes for the telephone system to complete its restart.
!
WARNINGS
· A shutdown must always be used to switch off the system. Simply removing the power cord or switching off the
power input may cause errors.
· This is not a polite shutdown, any users calls and services in operation will be stopped. Once shutdown, the system
cannot be used to make or receive any calls until restarted.
· The shutdown process takes up to a minute to complete. When shutdown, the CPU LED and the IP500 base card
LEDs 1 and 9 (if trunk daughter card fitted) will flash red rapidly. The memory card LEDs are extinguished. Do not
remove power from the system or remove any of the memory cards until the system is in this state.
· To restart a system when shutdown indefinitely, or to restart a system before the timed restart, switch power to
the system off and on again.
1. Press the Features soft key if shown. To do this during a call, press the
Features soft key.
2. Use the up and down
3. Use the up and down
present then you may not have been configured as a system phone user by your system administrator.
4. Enter your security PIN (login code) and press Done.
5. Use the up and down arrow keys to highlight System Shutdown. Press Select.
6. The current default timeout (10 minutes) setting is shown and can be used by pressing OK soft key. Otherwise
enter the timeout required in hours and minutes and then press the Ok soft key.
· The allowable range for the timeout is from 00:05 to 24:00. Note that the Ok soft key is not displayed if the
timeout entered is not within the allowed range.
· To enter the : symbol in the timeout press either the * or # key.
· To delete the previous digit or character entered press the
7. After pressing the Ok soft key, you will be asked to confirm whether you want to shutdown the telephone system.
Only proceed is you are sure. If you are not sure press Back.
8. If you press the Confirm soft key, the telephone system will switch itself to a shutdown state. This will disconnect
all current calls and services.
9600 Series Phone User Guide
IP Office Release 6.1
arrow keys to highlight Phone User. Press Select.
arrow keys to highlight System Administration. Press Select. If the option is not
System Administration: Setting the Time Offset
PHONE key and then press the
left arrow key.
Issue 02c (28 October 2010)
Page 129