Avaya IP Office Basic Edition Manual page 237

M7324/M7324N/M7310/M7310N/T7316/T7316E Phone
1. Do one of the following depending on whether you want to change the button programming of the extension you
are using or that of another extension.
To program the same extension
a. Press Feature and dial *1 or
*2 or *3.
·
If the system has a system
password set, it is requested.
Enter the password.
2. To select the button, press the corresponding button. For buttons up to 99, you can also dial the button number.
The current setting of the selected button is displayed.
3. Dial Feature 932.
4. At the CovOrig: prompt enter the extension number for which the button is being programmed.
5. At the CovDest: prompt enter the destination extension number for the call coverage calls.
6. The button function is changed to Cover O <covered extension> D <destination extension>.
·
To exit phone based administration at any time, press the Release button. To select a different process use the
Next Procedure or Previous Procedure buttons or dial another feature code.
ETR 18D/ETR 34D Phone
1. Do one of the following depending on whether you want to change the button programming of the extension you
are using or that of another extension.
To program the same extension
a. At the phone, press Feature 00.
b. Program Extension: is shown on the
display.
2. To select the button, press the corresponding button. For buttons up to 99, you can also dial the button number.
The current setting of that button is displayed.
3. Dial FEATURE 20.
4. At the Call Coverage Orig: prompt enter the extension number for which the button is being programmed.
5. At the Call Coverage Dest: prompt enter the destination extension number for the call coverage calls.
6. The button function is changed to Call Coverage O <covered extension> D <destination extension>.
·
Exit programming by pressing Feature 00. You can also exit programming mode by lifting the handset, then
placing it back in the cradle.
Phone Based Administration
IP Office Basic Edition
To program another extension
a. At either of the first two extensions on the system, press
**user (ie. Feature **8737).
·
If the system has a
password.
b. At the Extension: prompt enter the extension number of the extension you
want to program.
To program another extension
a. At either of the first two extensions on the system, press Feature
00 followed by two presses the first intercom or call appearance
button and one press of the second intercom or call appearance
button. Centralized Programming: is shown on the display.
b. At the Extension: prompt enter the number of the extension.
Comments on this document? infodev@avaya.com
Button Programming: Call Coverage
system password set, it is requested. Enter the
114
- Issue 6a (Thursday, February 22, 2018)
Feature
Page 237