Avaya IP Office Basic Edition Manual page 204

·
To exit phone based administration at any time, press the Release button. To select a different process use the
Next Procedure or Previous Procedure buttons or dial another feature code.
ETR 18D/ETR 34D Phone
1. Do one of the following depending on whether you want to change the button programming of the extension you
are using or that of another extension.
To program the same extension
a. At the phone, press Feature 00.
b. Program Extension: is shown on the
display.
2. To select the button, press the corresponding button. For buttons up to 99, you can also dial the button number.
The current setting of that button is displayed.
6. Enter the number of the extension to be programmed.
7. At the Button: prompt enter from 03 to 99 to select the line button for which you want to view the line ringing
setting.
8. The display will show LINE RINGING: and the current ring setting for the line on that button and the line number it
represents in the form <ring setting>-L<line number>.
·
I- = Immediate ring, D- = Delayed ring (5 seconds delay), N- = No ring.
8. To change the setting from its current value enter the button number again.
9. To view the setting of another line button enter the number of that button.
·
Exit programming by pressing Feature 00. You can also exit programming mode by lifting the handset, then
placing it back in the cradle.
Phone Based Administration
IP Office Basic Edition
To program another extension
a. At either of the first two extensions on the system, press Feature
00 followed by two presses the first intercom or call appearance
button and one press of the second intercom or call appearance
button. Centralized Programming: is shown on the display.
b. At the Extension: prompt enter the number of the extension.
Comments on this document? infodev@avaya.com
- Issue 6a (Thursday, February 22, 2018)
Page 204