Defining The Telegram; Copying The Address List - Siemens SIMOTION D4x5-2 DP/PN Operating Instructions Manual

The following PROFINET addresses have been defined for the PROFINET PN interfaces on
the SIMOTION D:
Table 5-2
PN interface
PNxIO
CBE30x2xPNxIO
5.5.3

Defining the telegram

The data exchange between the SIMATIC S7 and SIMOTION takes place via PROFINET. The
telegram used is the standard telegram in accordance with PROFIdrive profile V4.1 [Ref. 3].
Twenty function blocks (e.g. FB_CommonPLCToAddOn, FB_CommonAddOnToPLC) are
programmed in the AddOn technology to process communication telegrams (or interconnect
and convert signals) between SIMATIC S7 and SIMOTION.
In addition, the corresponding function blocks and data blocks in the application projects for
defined communication are available to users on the DVD.
5.6

Copying the address list

In SIMOTION, all communication with the I/O or with the master is performed via the address
list. An I/O array with process data must be created for receiving and sending for each function
module participating in communication.
The required I/O arrays are preferably copied from the application project to the user project
(with the Basic Technology).
The address list of the application project is shown below.
SC integrated STS, GSU
Operating Instructions, 07/2019, A5E48271265B AA
PROFINET PN interfaces on the SIMOTION D for AddOn technology
Communication between ...
SIMATIC S7 and SIMOTION D (Basic
and AddOn technology)
SIMOTION D and camera MV440 (not
necessary with UDP communication)
Configuration
5.6 Copying the address list
PN address
192.168.1.1
192.168.0.1
121