Siemens SIMOTION D4x5-2 DP/PN Operating Instructions Manual page 119

SIMATIC S7 hardware configuration
Copy the PNxIO station from the supplied application project into your user project. The name
is automatically changed when you paste the station. Open the station and change the name
back to the original name. The station must have the same name as the PN line of the
SIMOTION, i.e. also PNxIO. When you change the name, a window opens indicating that the
name has already been assigned and asking if you are referring to the same station. Confirm
this with "Yes".
Figure 5-11
You can now define the input and output addresses. In the application projects, these are
identical to the input/output addresses in the SIMOTION, but can be changed if required.
Once all the functions of the AddOn technology have been configured, the hardware
configurations must be compiled in the SIMATIC S7 and SIMOTION and loaded into the
controller.
The complete SIMATIC S7 and SIMOTION hardware is displayed in the "NetPro" screen
below. Although the PG/PC can be connected to any line, the PNxIO line is always selected in
the application projects. An active connection must be configured at the PG/PC, otherwise
routing to SINAMICS_Integrated is not possible. The PNxIO station image is automatically
inserted in NetPro during the hardware configuration process and must neither be changed nor
deleted. The MV440 is only displayed in NetPro if the camera was created in the HW Config of
the SIMOTION (not necessary for UDP).
SC integrated STS, GSU
Operating Instructions, 07/2019, A5E48271265B AA
Overview of the SIMATIC S7 hardware configuration
Configuration
5.5 PROFINET configuration
119