Siemens SIMOTION D4x5-2 DP/PN Operating Instructions Manual page 118

Configuration
5.5 PROFINET configuration
Figure 5-10
Note
If you have extended the address range by adding more addresses, you can no longer use the
PNxIO station from the supplied application project, as this will no longer match the address
range of the SIMOTION. In this case, create a new GSD file (in the HW Config of the
SIMOTION) and use the new PNxIO station from the hardware catalog (in the HW Config of the
SIMATIC S7).
After the GSD file has been created and installed, it can be found under Hardware catalog →
"PROFINET IO" → "Preconfigured Stations" → "D435" → "PNxIO".
118
Creating a GSD file
SC integrated STS, GSU
Operating Instructions, 07/2019, A5E48271265B AA