Configuration Mode - ZyXEL Communications MES-2110 User Manual

Chapter 23 Command Line Interface

23.7 Configuration Mode

When in Configuration mode, the command prompt is as follows:
MES-2110(config)#
There are 3 additional ancillary available while in Configuration mode. They are:
Table 79 Basic Commands
ANCILLARY TRIGGER
MVR While in Configuration mode:
Type mvr <1-4094> (where 1-4094)
is the MVR ID ranging from 1 to
4094) at the command line prompt
and then press
If no MVR exists, then this creates
one for you.
VLAN While in Configuration mode:
Type vlan <1-4094> (where 1-4094
is a VLAN ID ranging from 1 to 4094)
at the command line prompt and
then press
If no VLAN ID exists, then this
creates one for you.
Interface While in Configuration mode:
Type interface <port> (where port
is a port number) at the command
line prompt and then press
The following is a list of baseline Configuration mode commands:
Table 80 Configuration Mode Commands
COMMAND
configure terminal
abnormal detection <enable|disable>
abnormal duration <1-60>
abnormal interval <1-600>
abnormal permanently <yes|no>
abnormal threshold <2000-20000>
186
.
[ENTER]
[ENTER].
[ENTER]
DESCRIPTION
This mode allows to configure the MES-2110's
MVR IDs and their associated options.
See Section 23.8 on page 195
This mode allows you to configure the MES-
2110's VLAN IDs and their associated options.
See Section 23.9 on page 197
This mode allows you to configure the MES-
2110's port interfaces and their associated
options.
See Section 23.10 on page 198
DESCRIPTION
Toggles the Configuration mode, but only if you
are first in Privileged mode.
Enables or disables abnormal traffic detection.
Sets the abnormal traffic detection duration in
seconds (1-60).
Sets the protection interval in seconds (1-600).
Blocks any port permanently when abnormal
traffic is detected and this option is set to
Sets the threshold of traffic detection in packets
per second (2000-20,000).
.
for details.
for details.
for details.
.
yes
MES-2110 User's Guide