Link Aggregation Id; Static Trunking Example - ZyXEL Communications MES-2110 User Manual

Chapter 16 Link Aggregation
• You must connect all ports point-to-point to the same Ethernet switch and
configure the ports for LACP trunking.
• LACP only works on full-duplex links.
• All ports in the same trunk group must have the same media type, speed,
duplex mode and flow control settings.
Configure trunk groups or LACP before you connect the Ethernet switch to avoid
causing network topology loops.

16.2.1 Link Aggregation ID

LACP aggregation ID consists of the following information
Table 41 Link Aggregation ID: Local Switch
SYSTEM
PRIORITY
0000
Table 42 Link Aggregation ID: Peer Switch
SYSTEM
PRIORITY
0000

16.3 Static Trunking Example

This example shows you how to create a static port trunk group for ports 2-5.
Make your physical connections - make sure that the ports that you want to
1
belong to the trunk group are connected to the same destination. The following
figure shows ports 2-5 on switch A connected to switch B.
Figure 49 Trunking Example - Physical Connections
A
2. Port Priority and Port Number are 0 as it is the aggregator ID for the trunk group, not the individual port.
118
MAC ADDRESS KEY
00-00-00-00-00-00 0000
MAC ADDRESS KEY
00-00-00-00-00-00 0000
2
:
PORT PORT
PRIORITY NUMBER
00 0000
PORT
PORT NUMBER
PRIORITY
00 0000
B
MES-2110 User's Guide