ZyXEL Communications MES-2110 User Manual page 96

Chapter 11 Bridge
Table 27 Configuration > Bridge Menu > RSTP Per Port Config
LABEL
Edge
P2P
Undo
Apply
Port
Type
Priority (1~255)
Cost (1~65535)
Edge
P2P
Port Status
Port Role
96
DESCRIPTION
Select On when the port is connected to an end node (a computer
network card for example).
Select Off when the port is connected to a bridge node.
Select On when the port is connected to one bridge as a Point-to-
Point link type.
Select Off when the port is connected to multiple bridges as a
Shared Medium link type.
Select Auto to have the MES-2110 automatically determine the
link type.
Click this to restore your last saved settings.
Click Apply to save your changes to the MES-2110's run-time
memory. The MES-2110 loses these changes if it is turned off or
loses power, so use the Save Settings link in the navigation
panel to save your changes to the non-volatile memory when you
are done configuring.
This indicates the port index number.
This indicates the cable type connected to the port.
This indicates the port priority.
This indicates the path cost for the port.
This indicates whether the port is connected to an end node (On)
or a bridge node (Off).
This indicates whether the port is connected to one bridge (On),
multiple bridges (Off), or if the connection type is determined
automatically (Auto).
This indicates whether the port is Forwarding or Blocking frame
transmission.
This indicates the port behavior as a Disabled, Alternate,
Backup, Root, Designated or NonStp port.
MES-2110 User's Guide