ZyXEL Communications MES-2110 User Manual page 192

Chapter 23 Command Line Interface
Table 80 Configuration Mode Commands
COMMAND
qos ip-dscp-pri-queue <0~63>
<low|normal|preferred|high>
qos tag-pri-queue <0-7>
<low|normal|preferred|high>
rmon clear
snmp contact <contact-name>
snmp getcommunity <community-name>
snmp location <location-name>
snmp setcommunity <community-name>
snmp trapcommunity <index> <community-
string>
snmp trapenable <index> <enable|disable>
snmp trapip <index> <ip-address>
sntp <enable | disable>
sntp-NTP-primary-server <ip address>
sntp-NTP-secondary-server <ip address>
sntp poll_interval <value>
sntp time <yyyy:mo:dd:hh:mm:ss>
sntp timezone <+hh.mm | -hh.mm>
192
DESCRIPTION
Sets the QoS IP IP-DSCP Priority to queue
mapping. The default is low.
Set the QoS tag priority to queue mapping.
Clears the RMON information for ports 1~10.
Sets the SNMP system contact name.
: Enter up to 80 characters.
contact-name
Sets the SNMP GET community.
: Enter up to 30 characters.
community-name
Note: Only for SNMP v2c or lower.
Sets the SNMP system location.
: Enter up to 80 characters.
location-name
Sets the SNMP SET community.
: Enter up to 30 characters.
community-name
Note: Only for SNMP v2c or lower.
Sets the SNMP trap community.
: Enter an index number (1~5).
index
: Enter up to 30
community-string
characters.
Enables the SNMP trap.
: Enter an index number (1~5).
index
Sets the IP addresses of up to 5 SNMP
managers to receive SNMP traps.
: Enter an index number (1~5).
index
Enables and disables SNTP support.
Set SNTP primary server's IP address.
Set SNTP secondary server's IP address.
Sets the interval in specified hours between
SNTP requests.
Sets the local time by year (yyyy), month (mm),
day (dd), hour (hh), minutes (mm), and
seconds (ss).
Sets the timezone offset.
: Increases the timezone offset by the
+hh.mm
specified hours (hh) and minutes (mm).
: Increases the timezone offset by the
-hh.mm
specified hours (hh) and minutes (mm).
MES-2110 User's Guide