ZyXEL Communications MES-2110 User Manual page 69

Table 12 Configuration > Rmon Status (continued)
LABEL
RX
The following fields show detailed information about frames received.
InUnicasts
InBroadcasts
InPause
InMulticasts
InGoodOctetsHi
InGoodOctetsLo
InFCSErr
InMACRcvErr
InBadOctets
InUndersize
InFragments
InJabber
InOversize
TX
The following fields show detailed information about frames transmitted.
OutUnicasts
OutBroadcasts
Late
Excessive
Multiple
Single
Deferred
RX+TX
64 Octets
65to127 Octets
MES-2110 User's Guide
DESCRIPTION
This field shows the number of good unicast frames received.
This field shows the number of good broadcast frames received.
This field shows the number of 802.3x Pause frames received.
This field shows the number of good multicast frames received.
This field shows the number of good upper octet frames received.
This field shows the number of good lower octet frames received.
This field shows the number of frames received with Cyclic
Redundant Check (CRC) error(s).
This field shows the number of frames received with an RxErr signal
from the PHY.
This field shows the number of bad octet frames received.
This field shows the number of frames received that were too short
(shorter than 64 octets).
This field shows the number of frames received that were too short
(shorter than 64 octets) and were received with with Cyclical
Redundancy Check (CRC) errors.
This field shows the number of frames received with a length that
exceeds the maximum octet size and were received with CRC errors.
This field shows the number of frames received with a length that
was out of range.
This field shows the number of good unicast frames transmitted.
This field shows the number of good broadcast frames transmitted.
This is the number of times a late collision is detected, that is, after
512 bits of the frames have already been transmitted.
This is a count of frames for which transmission failed due to
excessive collisions. Excessive collision is defined as the number of
maximum collisions before the retransmission count is reset.
This is a count of successfully transmitted frames for which
transmission was inhibited by more than one collision.
This is a count of successfully transmitted frames for which
transmission is inhibited by exactly one collision.
This is a count of frames for which transmission delayed due to busy
traffic. The deferred frames are waiting to be transmitted from the
MES-2110 buffer. This counter only works for the half-duplex mode.
This field shows the number of frames (including bad frames)
received that were 64 octets in length.
This field shows the number of frames (including bad frames)
received that were between 65 and 127 octets in length.
Chapter 7 Configuration
69