The Rstp System Configuration Screen - ZyXEL Communications MES-2110 User Manual

Chapter 11 Bridge
The following table describes the labels in this screen.
Table 25 Configuration > Bridge Menu > Bridge Config
LABEL
Ring Protocol
Port
Undo
Apply

11.3 The RSTP System Configuration Screen

You must first enable RSTP in the Bridge Configuration screen in order to open
this screen.
Click Configuration > Bridge Menu > RSTP System Config to open the
following screen.
Figure 37 Configuration > Bridge Menu > RSTP System Config
92
DESCRIPTION
Select RSTP (802.1W) to enable RSTP.
Select Disable if you do not want to use this feature.
Select Enable to have the port participate in RSTP when you
select RSTP (802.1W) in the Ring Protocol field.
Select Disable so that the port will not participate in RSTP when
you select RSTP (802.1W) in the Ring Protocol field.
Select Tunnel so that the port will not participate in RSTP. When
the tunnel port receives Bridge Protocol Data Units (BPDU)
frames, the MES-2110 forwards the frames to other tunnel ports.
Click this to restore your last saved settings.
Click Apply to save your changes to the MES-2110's run-time
memory. The MES-2110 loses these changes if it is turned off or
loses power, so use the Save Settings link in the navigation
panel to save your changes to the non-volatile memory when you
are done configuring.
MES-2110 User's Guide