Vlan Id Priority Example; Interface Mode - ZyXEL Communications MES-2110 User Manual

Chapter 23 Command Line Interface

23.9.1 VLAN ID Priority Example

This example assigns port 1 as a tagged port for VLAN 1 and sets the priority of all
incoming packets from VLAN 1 to priority 3.
MES-2110> enable
MES-2110# configure terminal
MES-2110(config)# vlan 1
MES-2110(config-vlan)# tagging 1
MES-2110(config-vlan)# vid-priority 3
MES-2110(config-vlan)# use-vid-priority yes
MES-2110(config-vlan)# exit
MES-2110(config)# interface port-channel 1
MES-2110(config-interface)# vid-pri-override enable
MES-2110(config-interface)# exit
MES-2110(config)# exit
MES-2110# show priority-override
port
=================================================================
01
02
03
04
05
06
07
08
09
10
MES-2110# show vlan tag-base vlan-table
No. VLAN-ID
=========================================================
1 1
2 24
MES-2110#

23.10 Interface Mode

This is an ancillary mode of Configuration mode. You must be in Configuration
mode for these commands to work.
When in Interface-Configuration mode, the command prompt is as follows:
MES-2110(config-interface)#
198
vid-pri-override
enabled
disabled
disabled
disabled
disabled
disabled
disabled
disabled
disabled
disabled
Priority
3
0
da-pri-override sa-pri-override
disabled
disabled
disabled
disabled
disabled
disabled
disabled
disabled
disabled
disabled
Pri-override 1234567890 (T:tag, -:nomember)
Yes TUUUUUUUUU
No ----------
disabled
disabled
disabled
disabled
disabled
disabled
disabled
disabled
disabled
disabled
1 (M:member, U:untag)
.
MES-2110 User's Guide