12.3 The VLAN Type Screen
Use this screen to select the VLAN type. Click Configuration > VLAN Menu >
VLAN Type to open the following screen.
Figure 39 Configuration > VLAN Menu > VLAN Type
The following table describes the labels in this screen.
Table 29 Configuration > VLAN Menu > VLAN Type
LABEL
VLAN Type
Undo
Apply
12.4 The Port-Based VLAN Screen
Port-based VLANs are VLANs where the frame forwarding decision is based on the
destination MAC address and its associated port.
Port-based VLANs require allowed outgoing ports to be defined for each port.
Therefore, if you wish to allow two subscriber ports to talk to each other, for
example, between conference rooms in a hotel, you must define the egress (an
egress port is an outgoing port, that is, a port through which a data frame leaves)
for both ports.
Port-based VLANs are specific only to the MES-2110 on which they were created.
MES-2110 User's Guide
DESCRIPTION
Use this to set the MES-2110 to Port-Based or Tag-
Based(802.1q) VLAN mode.
Click this to restore your last saved settings.
Click Apply to save your changes to the MES-2110's run-time
memory. The MES-2110 loses these changes if it is turned off or
loses power, so use the Save Settings link in the navigation
panel to save your changes to the non-volatile memory when you
are done configuring.
Chapter 12 VLAN
99