Mvr Group Configuration - ZyXEL Communications MES-2110 User Manual

Table 49 Configuration > IGMP Menu > MVR (continued)
LABEL
Port
Source Port
Receiver Port
None
Tagging
All Port
Tagging
Undo
Apply
MVR Status
VLAN
Active
Query Mode
Name
Mode
Source Port
Receiver Port
Tagging Port
Delete
Undo

17.6 MVR Group Configuration

All source ports and receiver ports belonging to a multicast group can receive
multicast data sent to this multicast group.
Configure MVR IP multicast group address(es) in the Group Configuration
screen. Click Group Configuration in the MVR screen.
MES-2110 User's Guide
DESCRIPTION
This field displays the port number on the MES-2110.
Select this option to set this port as the MVR source port that sends and
receives multicast traffic. All source ports must belong to a single
multicast VLAN.
Select this option to set this port as a receiver port that only receives
multicast traffic.
Select this option to set the port not to participate in MVR. No MVR
multicast traffic is sent or received on this port.
Select this checkbox if you want the port to tag the VLAN ID in all
outgoing frames transmitted.
Use this to select between Source Port, Receiver Port or None.
Select this checkbox if you want the ports to tag the VLAN ID in all
outgoing frames transmitted.
Click this to load your last saved settings.
Click Apply to save your changes to the MES-2110's run-time memory.
The MES-2110 loses these changes if it is turned off or loses power, so
use the Save Settings link in the navigation panel to save your changes
to the non-volatile memory when you are done configuring.
This field displays the multicast VLAN ID.
This field displays whether the multicast group is enabled or not.
This field displays whether the query mode is enabled or not.
This field displays the descriptive name for this setting.
This field displays the MVR mode.
This field displays the source port number(s).
This field displays the receiver port number(s).
This field displays which port tags outgoing frames with the VLAN ID.
To delete a multicast VLAN(s), select the rule(s) that you want to
remove in the Delete column, then click the Delete button.
Click this to clear the Delete check boxes.
Chapter 17 IGMP
131