The Sntp Screen - ZyXEL Communications MES-2110 User Manual

Chapter 22 Mgmt Config and System Restart Menu
managers. Use this screen to configure the trap manager settings. Click Mgmt
Config > SNMP Config > IP Trap Manager to open the following screen.
Figure 83 Mgmt Config > SNMP Config > IP Trap Manager
The following table describes the labels in this screen.
Table 67 Mgmt Config > SNMP Config > IP Trap Manager
LABEL
IP Address
Community Name
Status
Undo
Apply

22.4 The SNTP Screen

Use this screen to configure the time settings on the MES-2110. You can configure
the MES-2110 to get the time and date information from a time server using
Simple Network Time Protocol (SNTP). You can also configure two servers. If the
first one is down, the MES-2110 will try to connect to the second one.
168
DESCRIPTION
Enter the IP addresses of up to five managers to send your SNMP
traps to.
Enter the community string.
Use this to enable or disable the trap manager feature.
Click this to restore your last saved settings.
Click Apply to save your changes to the ZyXEL Device's run-time
memory. The ZyXEL Device loses these changes if it is turned off
or loses power, so use the Save Settings link in the navigation
panel to save your changes to the non-volatile memory.
MES-2110 User's Guide