ZyXEL Communications MES-2110 User Manual page 202

Chapter 23 Command Line Interface
Table 83 Interface Mode Commands
COMMAND
storm-control broadcast-limit [cr |
<low|medium|high> <rate>]
storm-control multicast-limit [cr |
<low|medium|high> <rate>]
storm-control dlf [cr |<low|medium|high>
<rate>]
vid-pri-overide <enable|disable>
vlan-stacking role <normal|access|tunnel>
202
DESCRIPTION
Sets the broadcast storm control for the current
port(s).
: Enter nothing for this field and just press
cr
[Enter] to enable broadcast packet limits on the
current port(s).
: 64K~960K (64..960) in 64k steps.
low
: 1~100M (1..100) in 1M steps.
medium
: 100~1000M (110..1000) in 10M steps.
high
Sets the multicast storm control for the current
port(s).
: Enter nothing for this field and just press
cr
[Enter] to enable multicast packet limits on the
current port(s).
: 64K~960K (64..960) in 64k steps.
low
: 1~100M (1..100) in 1M steps.
medium
: 100~1000M (110..1000) in 10M steps.
high
Sets the DLF storm control for the current
port(s).
: Enter nothing for this field and just press
cr
[Enter] to enable DLF packet limits on the
current port(s).
: 64K~960K (64..960) in 64k steps.
low
: 1~100M (1..100) in 1M steps.
medium
: 100~1000M (110..1000) in 10M steps.
high
Enables or disables the VLAN ID priority override
for the current port(s).
Sets the VLAN stacking port roles of the current
port(s.)
: The device ignores frames received (or
normal
transmitted) on this port with VLAN stacking
tags.
: The device adds the SP TPID tag to all
access
incoming frames received on this port.
: Use this for egress ports at the edge of
tunnel
the service provider's network.
Note: In order to support VLAN stacking on a
port, the port must allow frames of 1526
bytes (1522 bytes + 4 bytes for the
second tag) to pass through it.
MES-2110 User's Guide