ZyXEL Communications MES-2110 User Manual page 159

Table 60 Configuration > QoS Menu > Base Configuration
LABEL
Port
Priority Mode
IP Over Tag
All Port
Undo
Apply
QoS Base Status
Port1-10
Schedule
Priority Mode
IP Over Tag
MES-2110 User's Guide
DESCRIPTION
This label shows the port you are configuring.
Select a priority mode for the port.
802.1p Priority uses port priority as queuing basis. Assign a
priority level to each port in the 802.1p Priority screen
21.3 on page 160).
Tag Priority uses VLAN tag priority as queuing basis. See
Section 21.4 on page 161
priority.
IP ToS Priority uses IP DSCP priority as queuing basis. See
Section 21.5 on page 161
priority.
IP & Tag Priority uses both IP DSCP priority and tag priority as
queuing basis.
Use this to enable or disable IP Over Tag on the port.
When you enable this feature and the MES-2110 receives a frame
containing both IP DSCP and tag priority information, the MES-
2110 will only use the IP DSCP priority information.
Use this to set the priority mode for all ports.
Click this to load your last saved settings.
Click Apply to save your changes to the ZyXEL Device's run-time
memory. The ZyXEL Device loses these changes if it is turned off
or loses power, so use the Save Settings link in the navigation
panel to save your changes to the non-volatile memory.
This is the port number.
This is the schedule mode used on the MES-2110.
This is the priority mode used on the port.
This shows whether the IP over tag feature is enabled or disabled
on the MES-2110.
for more details on configuring tag
for more details on configuring IP DSCP
Chapter 21 QoS
(Section
159