ZyXEL Communications MES-2110 User Manual page 188

Chapter 23 Command Line Interface
Table 80 Configuration Mode Commands
COMMAND
dot1x enable
dot1x reauth-max <1~10>
dot1x guest-vlan <1-4094>
dot1x radius-server server-ip <ip-address>
dot1x radius-server shared-secret <string>
dot1x radius-server server-udp-port <1-
65535>
dot1x radius-server accounting-port <1-
65535>
dot1x radius-server timeout <1-300>
email-alarm disable
email-alarm enable
email-alarm from <string|cr>
email-alarm server <ip-address>
email-alarm to [<id> <string>
<enable|disable>] | [<id>]
email-alarm type
<coldstart|warmstart|rj45up|rj45down|gigeu
p|gigedown|confchange|newroot1d|topochange
1d|arpinspectionover> <enable|disable>
188
DESCRIPTION
Enables 802.1x on the device.
Sets the maximum number of times re-
authentication can be used (1~10). The default
is 2 times. This kind of authentication method is
port-based.
Sets the VLAN ID of the guest VLAN. This must
be an existing VLAN.
Sets the RADIUS server's IP address.
Sets the password for RADIUS server access.
: Enter a maximum of 29 characters.
string
Sets the UDP port number of the RADIUS server.
The default is 1812.
Sets the accounting port of the RADIUS server.
The default is 1813.
Sets the timeout period of the RADIUS server.
The default is 30.
Disables the email alarm. This is the default.
Enables the email alarm.
Sets the email alarm's "from" field to the
specified string.
: Enter up to 63 characters.
string
: Leave this blank and press the [Enter] key
cr
to clear the email-alarm from setting.
Sets the email alarm's server to the specified IP
address.
Sets the email alarm's "to" field.
: Enter an ID number for this recipent (1~5).
id
If you enter just the ID and no other paramters
( or
string enable|disable
setting is cleared for that ID.
: Enter the recipient's email address.
string
: Select whether to enable
enable|disable
this recipient or disable it. When disabled, no
alarm emails are sent to that recipient.
Sets the email alarm type. When one of these
events occurs and you have enabled that email
alarm type, the device sends out an alarm
email. You must configure each event
individually.
For example:
email-alarm type coldstart
. This enables it for the coldstart event.
enable
If you want to also enable it for the warmstart
event, you must configure it separately:
email-alarm type warmstart enable
), then this
.
MES-2110 User's Guide