ZyXEL Communications MES-2110 User Manual page 199

Note: These commands only apply to the ports specified when you enter Interface
Configuration mode.
Table 83 Interface Mode Commands
COMMAND
interface port-channel <port-list>
abnormal-detection-enable
active
arp-inspection-trust
auto-negotiation
bandwidth-limit egress <cr>|
<low|medium|high> <rate>
bandwidth-limit ingress <low|medium|high>
<rate>
bpdu-mode <on|off|tunnel>
da-pri-override <enable|disable>
dhcp snooping trust
egress-set <port-list>
flow-control
MES-2110 User's Guide
Chapter 23 Command Line Interface
DESCRIPTION
Enters Interface Configuration mode for the
specified port(s).
Enables port detection for the current port(s).
Enables the current port(s).
Enables ARP inspection trust for the current
port(s). When enabled, the device does not
discard ARP packets on trusted ports.
Enables auto-negotiation for the current port(s).
Sets the egress rate for the current port(s).
: Press without entering any other
cr [ENTER]
parameters to enable egress bandwidth control
on the current port(s).
: 64K~960K (64..960) in 64k steps.
low
: 1~100M (1..100) in 1M steps.
medium
: 100~1000M (110..1000) in 10M steps.
high
Sets the ingress rate for the current port(s).
: Press without entering any other
cr [ENTER]
parameters to enable egress bandwidth control
on the current port(s).
: 64K~960K (64..960) in 64k steps.
low
: 1~100M (1..100) in 1M steps.
medium
: 100~1000M (110..1000) in 10M steps.
high
Sets the BPDU packet process mode for the
current port(s).
Sets the destination MAC priority override for the
current port(s).
Sets DHCP snooping trust for the current port(s).
Trusted ports are connected to DHCP servers or
other switches, and the device discards DHCP
packets from trusted ports only if the rate at
which DHCP packets arrive is too high.
Sets the outgoing traffic port list for a port-base
VLAN for the current port(s).
Enables interface flow control for the current
port(s).
199