ZyXEL Communications MES-2110 User Manual page 200

Chapter 23 Command Line Interface
Table 83 Interface Mode Commands
COMMAND
frame-type <fallback|check|secure>
isolate
lock-mac
mac-limit action <enable|disable>
mac-limit quantity <1-20>
mirror
name <string>
no abnormal
no active
no arp-inspection-trust
no bandwidth-limit egress
no bandwidth-limit ingress
no dhcp snooping trust
no flow-control
no auto-negotiation
no isolate
no lock-mac
no mirror
no broadcast-limit
200
DESCRIPTION
Sets the port frame type for the current port(s).
You can choose to accept both non-member and
untagged incoming frames (fallback), just
untagged incoming frames (check) or drop all
non-member and untagged incoming frames on
a port (secure).
: Accepts incoming frames
fallback
(nonmember forward/untag forward).
: Accepts incoming frames (nonmember
check
drop/untag forward).
: Accepts incoming frames (nonmember
secure
drop/untag drop).
Isolates the specified prots. Isolated ports
belonging to the same VLAN do not
communicate with each other.
Locks the MAC configuration for the current
port(s).
Enables or disables the MAC limit for the current
port(s).
Sets the MAC limit quantity for the current
port(s).
Enables port mirroring for the current port(s).
Sets a name for the port for the current port(s).
: Enter up to 15 characters.
string
Disables individual port detection for the current
port(s).
Disables the current port(s).
Disables ARP inspection trust for the current
port(s).
Disables egress rate for the current port(s).
Disables ingress rate for the current port(s).
Disables DHCP snooping trust for the current
port(s).
Disables flow control on the interface for the
current port(s).
Disables auto-negotiation. for the current
port(s).
Disables port isolation for the current port(s).
Disables MAC locking for the port for the current
port(s).
Disables port mirroring for the current port(s).
Disables the broadcast packet limit for the
current port(s).
MES-2110 User's Guide