Igmp Vlan Query Mode - ZyXEL Communications MES-2110 User Manual

Chapter 17 IGMP
Table 46 Configuration > IGMP Menu > IGMP Config
LABEL
Apply
IGMP Snooping
IGMP VLAN Mode
IGMP Query Mode
IGMP VLAN
Immediate Leave
Static Query

17.2.1 IGMP VLAN Query Mode

Click Configuration > IGMP Menu > IGMP Config then click the IGMP VLAN
Query Mode link to open the following screen.
Figure 55 Configuration > IGMP Menu > IGMP VLAN Query Mode
The following table describes the labels in this screen.
Table 47 Configuration > IGMP Menu > IGMP VLAN Query Mode
LABEL
IGMP VLAN
Query Mode
Undo
126
DESCRIPTION
Click Apply to save your changes to the MES-2110's run-time
memory. The MES-2110 loses these changes if it is turned off or
loses power, so use the Save Settings link in the navigation
panel to save your changes to the non-volatile memory when you
are done configuring.
This indicates whether IGMP snooping is enabled or disabled for
this port.
This indicates whether the IGMP VLAN Mode is set to Auto or
Fixed for this port.
This indicates whether the IGMP Query Mode is set to Auto or
Disable for this port.
This indicates the static VLAN ID the MES-2110 uses to learn
multicast group membership.
This indicates whether Immediate Leave is enabled or disabled
for this port.
This indicates whether Static Query is enabled or disabled for
this port.
DESCRIPTION
Select an IGMP VLAN (previously configured in
page 124) from the list.
Select either Auto or Disable as the Query Mode for the specified
IGMP VLAN.
Click this to restore your last saved settings.
Section 17.2 on
MES-2110 User's Guide