The Dhcp Configuration Screen - ZyXEL Communications MES-2110 User Manual

The following table describes the labels in this screen.
Table 8 System Details > Board Info.
LABEL
Hardware Version
Firmware Version
Port Number

6.4 The DHCP Configuration Screen

Use this screen to turn on or off the DHCP client. Click System Details > DHCP
Config to open the following screen.
Figure 22 System Details > DHCP Config
The following table describes the labels in this screen.
Table 9 System Details > DHCP Config
LABEL
DHCP Client
DHCP Client State
DHCP Leased Time
DHCP Expiry Time
Undo
Apply
MES-2110 User's Guide
DESCRIPTION
This is the version number of the MES-2110's hardware.
This is the version number of the MES-2110's current firmware
including the date and time that the firmware is created.
This shows the number of available ports on the MES-2110.
DESCRIPTION
Use this to turn the DHCP client on or off. Turn on the DHCP client
if you have a DHCP server that can assign the MES-2110 an IP
address, subnet mask and a default gateway IP address
automatically.
This shows whether the DHCP client is Enabled or Disabled.
This is how long ago the MES-2110 got an IP address from a
DHCP server (if DHCP client is enabled).
This is how long there is to go before the MES-2110 will get a new
IP address from a DHCP server (if DHCP client is enabled).
Click this to restore your last saved settings.
Click Apply to save your changes to the ZyXEL Device's run-time
memory. The ZyXEL Device loses these changes if it is turned off
or loses power, so use the Save Settings link in the navigation
panel to save your changes to the non-volatile memory.
Chapter 6 System Details
63