ZyXEL Communications MES-2110 User Manual page 190

Chapter 23 Command Line Interface
Table 80 Configuration Mode Commands
COMMAND
lacp port <port> <active|passive>
lacp priority <0-65535>
lacp restart
lacp trunk <group number> member <port num>
<port num> <port num> ...
logins
loop detection <enable|disable>
loop mac <mac-address>
loop port <id> <enable|disable>
mac-aging-time <1-255>
mac-filter add-allow-mac <mac-address>
<port id> <priority> <override-
enable|override-disable>
mac-filter add-deny-mac <mac-address>
mac-filter delete <mac-address>
mac-limit <enable|disable>
mirror mode <all|disable>
mirror monitoring-port <port-id>
netmask <netmask>
no arp inspection enable
no arp inspection mac-filter <mac-address>
no arp inspection vlan <1-4094>
no dhcp client
no dhcp binding mac <mac-address>
no dhcp binding ip <ip-address>
no dhcp binding port <port-id>
no dhcp binding vid <vlan-id>
no dhcp smart-relay enable
190
DESCRIPTION
Sets the LACP port state to active or passive.
Sets the system priority for LACP.
Stores the LACP configurations and then restarts
them.
Sets the trunk control configuration.
Modifies the login account.
This prompts you to enter the old username and
password; to create a new username and
password; then set the login account's read/
writer permissions.
Enables or disables loop detection.
Sets the loop detection test frame MAC address.
Enables or disables individual port loop
detection.
Sets the MAC aging time configuration. The
default is 19 (which converts to 304 seconds).
To determine the number of seconds, multiply
the MAC aging time value you enter by 16.
Sets the static unicast MAC configuration.
Adds a specified MAC address to the deny MAC
configuration.
Deletes a static unicast MAC configuration.
Enables or disables MAC-limit configuration.
Sets the mirror mode.
Sets the mirror monitoring port.
Sets the netmask.
Disables ARP inspection.
Deletes the specified MAC address from the ARP
inspection filter.
Disables ARP inspection on the specified VLAN.
Disables the DHCP client.
Deletes the DHCP snooping static binding table
by MAC address.
Deletes the DHCP snooping static binding table
by IP address.
Deletes the DHCP snooping static binding table
by port.
Deletes the DHCP snooping static binding table
by VLAN ID.
Disables DHCP smart relay.
MES-2110 User's Guide