ZyXEL Communications MES-2110 User Manual page 112

Chapter 13 Bandwidth Control
The following table describes the related labels in this screen.
Table 38 Configuration > Bandwidth Control
LABEL
Bandwidth Control Configuration
Port Number
Mode
Rate Level
Rate Limit
Active
Undo
Apply
Bandwidth Control Status
Port
Ingress Limit This is the ingress rate limit on the port.
Active
Egress Limit
Active
112
DESCRIPTION
Use this to select a port number.
This shows the Ingress (incoming) or Egress (outgoing) mode.
Select a rate range from the list. Options are: 64K~960K (64+), 1M~100M
(1M+), 110M~1000M (10M+).
Specify the maximum bandwidth allowed for the traffic flow on a port. The
unit changes depending on how you configure in the Rate Level field. The
value you enter in this field must be within the rate level range.
Use this to enable or disable bandwidth control.
Click this to restore your last saved settings.
Click Apply to save your changes to the MES-2110's run-time memory.
The MES-2110 loses these changes if it is turned off or loses power, so use
the Save Settings link in the navigation panel to save your changes to the
non-volatile memory when you are done configuring.
This is the port number.
This shows whether bandwidth control for ingress traffic is enabled or
disabled on the port.
This is the egress rate limit on the port.
This shows whether bandwidth control for egress traffic is enabled or
disabled on the port.
MES-2110 User's Guide