Logging Out; Command Modes - ZyXEL Communications MES-2110 User Manual

23.3 Logging Out

Enter exit to log out of the CLI while in Basic mode.
Table 75 Exit Command
COMMAND
exit

23.4 Command Modes

The MES-2110 segregates commands by command mode. Commands for a
particular mode are only available once you set the device to that particular mode.
The following is list of available command modes.
Table 76 Basic Commands
MODE TRIGGER
Basic Log in.
Privileged While in Basic mode, type enable at
the prompt and then press
[ENTER]
Configuration While in Privileged mode:
Type configure terminal at the
prompt and then press
MES-2110 User's Guide
.
[ENTER]
Chapter 23 Command Line Interface
DESCRIPTION
Logs you out of the CLI while in Basic mode. If
in any other mode, then this command returns
you to the previous mode.
DESCRIPTION
This is the default command line interface
mode when you log into the device.
Commands are restricted in this mode.
See Section 23.5 on page 182
This mode a limited command set for
configuring some of the MES-2110's features.
See Section 23.6 on page 183
This mode allows to you configure all of the
MES-2110's advanced options.
. Configuration mode also has 3 ancillary
modes: MVR, VLAN, and Interface.
See Section 23.7 on page 186
for details.
for details.
for details.
181