ZyXEL Communications MES-2110 User Manual page 185

Table 78 Privileged Commands
COMMAND
show rstp
show sfp ddmi port <port-number>
show sfp serial-no port <port-number>
show sfp vendor port <port-number>
show snmp
show sntp
show sntp-timezone
show storm-control
show syslog [<begin:end>]
show syslog-config
show version
show vlan port-base
show vlan stacking
show vlan tag-base management-VLAN
show vlan tag-base vlan-id
show vlan tag-base port-info
show vlan tag-base vlan-table
show vlan type
write memory
MES-2110 User's Guide
Chapter 23 Command Line Interface
DESCRIPTION
Displays the RSTP configuration.
Displays the SFP fiber port DDMI information for
the specified port.
Displays the SFP serial number for the specified
port.
Displays the SFP vendor name for the specified
port.
Displays the snmp configuration.
Displays the SNTP configurations.
Displays a list of time zones and their GMT offset.
Displays the storm control configuration.
Displays all syslog messages.
You can also specify a range of syslog messages.
: Enter the first syslog message to display.
begin
: Enter the last syslog message to display.
end
Displays the syslog configuration.
Displays the system version.
Displays the port-base VLAN.
Displays the VLAN stacking status.
Displays the VLAN for the management switch.
Displays the tag-base VLAN ID.
Displays the tag-base port information.
Displays tag-base VLAN table.
Displays the VLAN type.
Saves the current configuration, including all
changes made since the last save, to flash.
Note: You must use this command to
permanently save any changes you
make while using the MES-2110
command line interface.
185