ZyXEL Communications MES-2110 User Manual page 132

Chapter 17 IGMP
Note: A port can belong to more than one multicast VLAN. However, IP multicast
group addresses in different multicast VLANs cannot overlap.
Figure 60 Configuration > IGMP Menu > MVR > Group Configuration
The following table describes the labels in this screen.
Table 50 Configuration > IGMP Menu > MVR > Group Configuration
LABEL
Group Configuration
Multicast
VLAN ID
Group ID
Start
Address
Quantity
Undo
Add
MVR Group Status
MVLAN
Group ID
Address
Delet All
Delete
Group
Undo
132
DESCRIPTION
Select a multicast VLAN ID (that you configured in the MVR screen) from
the drop-down list box.
Enter a group number for identification purposes.
Enter the starting IP multicast address of the multicast group in dotted
decimal notation.
Refer to Section 17.1.1 on page 123
addresses.
Specify the number of IP addresses to include in the multicast group.
Click this to load your last saved settings.
Click Add to save your changes to the MES-2110's run-time memory. The
MES-2110 loses these changes if it is turned off or loses power, so use the
Save link on the top navigation panel to save your changes to the non-
volatile memory when you are done configuring.
This field displays the multicast VLAN ID.
This field displays the ID number that identifies the multicast group.
This field displays the starting IP address of the multicast group.
Select the check box and click the Delete button to remove all configured
rules.
Select the check box in the Delete Group field and click Delete to remove
the selected entry(ies) from the table.
Select this to clear the checkbox(es) in the table.
for more information on IP multicast
MES-2110 User's Guide