ZyXEL Communications MES-2110 User Manual page 100

Chapter 12 VLAN
This screen is available only when you select Port-Based in the VLAN Type
screen. Click Configuration > VLAN Menu > Port-Based to open the following
screen.
Figure 40 Configuration > VLAN Menu > Port-Based
The following table describes the labels in this screen.
Table 30 Configuration > VLAN Menu > Port-Based
LABEL
Port-Based VLAN Configuration
Port Number
Port1-10
Switch Management
Apply
Port-Based VLAN Status
Port Number
Port1-10
Switch Management
100
DESCRIPTION
Use this to select the port you are configuring.
Select the subscriber ports that can talk to each other.
Use this to enable or disable switch management via the web
configurator, Telnet or SNMP manager. Select the port through
which you can manage the MES-2110. If you disable this feature,
then you cannot access the web configurator from a computer
connected to this port.
Click Apply to save your changes to the MES-2110's run-time
memory. The MES-2110 loses these changes if it is turned off or
loses power, so use the Save Settings link in the navigation
panel to save your changes to the non-volatile memory when you
are done configuring.
This is the port number.
This shows the subscriber ports that can talk to each other.
This shows whether switch management is enabled or disabled.
MES-2110 User's Guide