ZyXEL Communications MES-2110 User Manual page 33

Pull the transceiver out of the slot.
3
Figure 12 Removing the Fiber Optic Cables
Figure 13 Opening the Transceiver's Latch Example
Figure 14 Transceiver Removal Example
3.2 Power Connections Overview
Use the following procedures to connect the MES-2110 to a power source after
you have installed it.
Note: Check the power supply requirements in
sure you are using an appropriate power source.
Keep the power supply switch and the MES-2110's power switch in
the OFF position until you come to the procedure for turning on
the power.
Use only power wires of the required diameter for connecting the MES-
2110 to a power supply.
MES-2110 User's Guide
Chapter 3 Hardware Overview
Chapter 25 on page 215
, and make
33