The Port Status Screen - ZyXEL Communications MES-2110 User Manual

Table 10 Configuration > Port Configuration
LABEL
Duplex
AUTO
Flow-Control
Undo
Apply

7.3 The Port Status Screen

To view the port statistics, click Configuration > Port Status to display the
Status screen as shown next.
Figure 25 Configuration > Port Status
The following table describes the labels in this screen.
Table 11 Configuration > Port Status
LABEL
Port
Name
Type
Admin
MES-2110 User's Guide
DESCRIPTION
This indicates the port's duplex mode (Half or Full).
This indicates whether auto-negotiation for this port is enabled or
disabled.
This indicates whether flow control for this port is enabled or
disabled.
Click this to restore your last saved settings.
Click Apply to save your changes to the ZyXEL Device's run-time
memory. The ZyXEL Device loses these changes if it is turned off
or loses power, so use the Save Settings link in the navigation
panel to save your changes to the non-volatile memory.
DESCRIPTION
This identifies the Ethernet port.
This is the name you assigned to this port in the Configuration > Port
Configuration screen.
This is the type of connector for each port. Port 1-8 are RJ-45 ports for
Ethernet connections. Port 9-10 are Gigabit SFP ports for fiber
connections.
This shows whether administrative access is Enabled or Disabled on the
port. When administrative access is disabled on the port, users cannot
manage the MES-2110 via that port.
Chapter 7 Configuration
67