ZyXEL Communications MES-2110 User Manual page 201

Table 83 Interface Mode Commands
COMMAND
no multicast-limit
no dlf-limit
no dot1x port-control
no dot1x guest-vlan
no dot1x reauth
8021p-priority <0-7>
pvid <1-4094>
qos-priority-mode <default|tag|ip|ip&tag>
qos-ipdscp-over-tag <enable|disable>
dot1x reauth-period <1-999999>
dot1x enable
dot1x reauth enable
dot1x guest-vlan enable
rstp-edge <on|off>
rstp-p2p <auto|on|off>
rstp-path-cost <0-65535>
rstp-priority <0-255>
sa-pri-override <enable|disable>
speed-duplex <10f|10h|100f|100h|1000f>
sfp-speed <100|1000|1000-no-auto>
MES-2110 User's Guide
Chapter 23 Command Line Interface
DESCRIPTION
Disables the multicast packet limit for the
current port(s).
Disables the DLF packet limit for the current
port(s).
Disables port control of 802.1x for the current
port(s).
Disables guest VLAN for the current port(s).
Disables reauthentication of 802.1x for the
current port(s).
Sets default ingress priority to use when no
priority information avilable for the current
port(s).
Sets the PVID for the current port(s).
Sets the QoS priority mode for the current
port(s).
: Port Priority.
default
: IEEE Tagged Frame Priority.
tag
: IPv4 and IPv6 Frame Priority.
ip
: IPv4 and IPv6 with IEEE Tagged Frame
ip&tag
Priority.
Sets the QoS ipdscp over tag priority for the
current port(s).
Set reauthentication period for the current
port(s). The default is 3600.
Enable 802.1x port control for the current
port(s).
Enable 802.1x reauthentication for the current
port(s).
Enables guest VLAN for the current port(s).
Sets the RSTP port edge for the current port(s).
Sets the RSTP port point-to-point (p2p) option
for the current port(s).
Sets the RSTP port path cost for the current
port(s). The default is 1000M=4, 100M=19.
Sets the RSTP port priority for the current
port(s). The default is 128.
Sets the source MAC priority override for the
current port(s).
Sets the duplex and speed mode for the current
port(s).
Sets the SFP fiber speed for the current port(s).
201