201I Server Component Diagram: Exploded View - Avaya CallPilot 201i Maintenance And Diagnostics

Performing hardware maintenance and mechanical assembly
To replace the server
1. If the installed server is functional, perform a complete backup of the hard disk as
2. Use the Maintenance screen in CallPilot Manager to take the installed MPC-8 cards
3. Remove the MPC-8 cards from the faceplate of the server (see
4. Shut down the installed server (refer to "Starting up and shutting down the Avaya
5. Power down the server by unseating it from the back plane. Wait 15 seconds to
6. Disconnect all peripherals from the server.
7. Remove the server from the switch (see
8. Remove the software feature key (dongle) from the defective server, and then install
9. Remove the hard drive from the defective server, and then install it in the
10. Install the replacement server on the switch, and then reconnect the peripherals.
11. Install the MPC-8 cards removed from the defective server (see
12. Boot the server to the operating system.
13. Run the Configuration Wizard to configure the new hardware.

201i server component diagram: exploded view

The following diagram identifies component locations on the 201i server.
94 Avaya CallPilot® 201i Server Maintenance and Diagnostics
a precautionary measure.
out of service (see Starting and stopping components
Multimedia Processing Cards
CallPilot® server" in the CallPilot Installation and Configuration Task List).
complete powering down, then remove the server.
page 92).
it in the replacement server (see
replacement server (see
card on page 113).
For instructions, refer to the CallPilot <switch model> and Avaya CallPilot Server
Configuration guide for your switch and server.
on page 110).
Removing the server from the switch
Replacing the software feature key
To remove the IDE hard drive
on page 61).
Replacing
on page 108).
on page 99).
To install an MPC-8
December 2010
on