The Netstat Command; Netstat Command Syntax - Avaya CallPilot 201i Maintenance And Diagnostics

Using the operating system online diagnostic tools
Parameter
interval
To run the nbtstat command from the operating system
1. Click Start → Programs → Accessories → Command Prompt to display the
2. At the prompt, type nbtstat with the required parameters.
3. Press Enter.
4. Type Exit to exit the Command Prompt window.

The netstat command

The netstat command displays current TCP/IP network connections and protocol statistics.

Netstat command syntax

The netstat command uses the following syntax:
netstat [-a] [-e] [-n] [-s] [-p proto] [-r] [interval]
-a
-e
-n
-s
-p proto
-r
46 Avaya CallPilot® 201i Server Maintenance and Diagnostics
Displays selected statistics, pausing interval seconds between each
display. Press Ctrl+C to stop displaying statistics. Without this
parameter, nbtstat prints the current configuration information once.
command prompt window.
Result: The Command Prompt window appears.
Result: The system runs the nbtstat utility.
Parameter
Description
Description
Displays all connections and listening ports.
Displays Ethernet statistics. This can be combined
with the -s option.
Displays addresses and port numbers in numerical
form.
Displays per-protocol statistics.
Shows connections for the protocol specified by proto.
Proto can be tcp or udp. If used with the -s option, proto
can be tcp, udp, or ip.
Displays the contents of the routing table.
December 2010