Avaya CallPilot 201i Maintenance And Diagnostics page 102

Performing hardware maintenance and mechanical assembly
4. Lift the hard drive assembly away from the motherboard.
5. Do the following:
6. Disconnect the black hard drive adaptor from the hard drive
7. Detach the hard drive by removing the four screws on the bottom of the hard drive
8. Fasten the new drive to the hard drive assembly bracket using the four screws from
9. Connect the black hard drive adaptor to the hard drive.
10. With the drive on top, and the cable facing the top of the server, mount the drive
11. Fasten the two screws on the back of the motherboard.
12. Fasten the screw on the stiffening cage.
102 Avaya CallPilot® 201i Server Maintenance and Diagnostics
IF you are
replacing a 3.5 inch hard drive Go to
replacing a 2.5 inch hard drive continue with step 6
assembly.
the replacement kit.
assembly. The slot in the drive assembly goes over the PCI connector on the
motherboard.
THEN
To replace a 3.5 inch drive with a 2.5 inch
hard drive on page 103You do not need to
remove the drive from the assembly.
December 2010