Avaya CallPilot 201i Maintenance And Diagnostics page 105

9. connect the original power cable to the adaptor, and fasten the connectors to the
Figure 7: Bottom view of hard drive assembly
10. With the drive on top, and the cable facing the top of the server, mount the drive
11. Fasten the two screws on the back of the motherboard. These screws are from the
12. Fasten the screw on the stiffening cage. This screw is from the original assembly
13. Fasten the two screws on the hard drive stiffener cage along the backplane edge
14. Connect the flat flexible data cable from the drive to the motherboard connector
Avaya CallPilot® 201i Server Maintenance and Diagnostics
bracket with the tie wrap. The tie wrap goes through the rectangular hole and
between the two inner power wires.
assembly. The slot in the drive assembly goes over the PCI connector on the
motherboard.
Note:
The PCI connector on the motherboard is reserved for future use
original assembly.
of the server. These screws are item number 8 in the replacement kit
Caution:
Risk of equipment damage
Hard drive assembly diagram
December 2010 105