Equipment Required; What Is Next; Replacing The Server; Introduction - Avaya CallPilot 201i Maintenance And Diagnostics

Equipment required

The following equipment is required for this procedure:
• antistatic mat
• antistatic wrist strap
To remove the server from the switch
1. Power down the server by unseating it from the back plane. Wait 15 seconds to
2. Turn off the monitor.
3. Disconnect the monitor, keyboard, and mouse.
4. Power down the peripheral SCSI devices, and disconnect the SCSI cable.
5. Open the lock latches at the top and bottom of the server.
6. Grip the faceplate, and then unseat the server from the switch. Wait 15 seconds,
7. Place the server on a clean, static-resistant surface.

What is next?

Replace and upgrade components, as required.

Replacing the server

Introduction

Replace the server only if you are instructed to do so. For activities that are not supported as
field procedures, you must return the server to Avaya for service.
This section summarizes the procedure for replacing the server. References are made to
specific component replacement procedures where applicable.
Avaya CallPilot® 201i Server Maintenance and Diagnostics
complete powering down, then remove the server.
For instructions, refer to the CallPilot Installation and Configuration Task List
(NN44200-306).
then remove the server.
Equipment required
December 2010 93