Interpreting The Hex Display; Introduction; Hex Display Codes - Avaya CallPilot 201i Maintenance And Diagnostics

Troubleshooting your Avaya CallPilot® system
IF the S LED is
blinking
lit solid

Interpreting the HEX display

Introduction

This section describes the codes that can appear on the HEX display during startup or normal
201i server operation.
Note:
For a description of the codes that appear during startup diagnostics, see
codes on page 28. For a description of the startup sequence, see
description

HEX display codes

During startup and normal 201i server operation, the HEX display on the server faceplate
displays one of the codes in the following table:
HEX display output
T:XX
F:XX
P:XX
26 Avaya CallPilot® 201i Server Maintenance and Diagnostics
the SCSI device is being accessed.
the software driver has loaded, but the SCSI device is
not connected.
on page 31.
Startup codes
The 8051 controller is starting and running
diagnostics. These diagnostics are performed during
a cold restart (when the server is powered up, or if you
press Reset on the 201i server's faceplate).
For more details, see
page 28.
At least one diagnostic failed. The displayed error
code represents the first failed diagnostic.
For more details, see
page 28.
An Extended POST error has occurred, where XX
represents a two-character code. If the error is a
THEN
Startup sequence
Description
Startup diagnostic codes
Startup diagnostic codes
Startup diagnostic
on
on
December 2010