Avaya CallPilot 201i Maintenance And Diagnostics page 104

Performing hardware maintenance and mechanical assembly
2. Place the 2.5 inch hard drive in the palm of your hand with the screw holes facing
3. Place the hard drive bracket over the hard drive with the data connector facing the
4. Insert the four screws, listed as kit item 3, in the mounting holes, and tighten them
Figure 6: Hard drive mounted on bracket
5. Attach the black cable adaptor to the IDE connector on the hard drive. The power
6. Attach the flat flexible cable to the black connector. The red stripe on the ribbon
7. Turn the drive assembly over with the hard drive facing up.
8. Loop the red and black power wires under the hard drive adaptor and mount the
104 Avaya CallPilot® 201i Server Maintenance and Diagnostics
7 1
8 2
upwards
notched end of the bracket.
cable pins go to the left side of the connector as you are facing it. Ensure the left-
most pins are connected. Four pins remain unconnected on the right side of the
connector.
cable goes to the end of the connector opposite from the power pins
Note:
The diagram below shows the bottom of the bracket assembly and hard drive.
power coupler between the two tabs on the bracket.
Flat flexible cable
Screws. These screws are shorter than the four
screws in item 3
December 2010