I/O Card Srx5K-4Xge-Xfp Specifications - Juniper SRX5400 Hardware Manual

SRX5400 Services Gateway Hardware Guide
LEDs
Serial Number Location
Related
Documentation

I/O Card SRX5K-4XGE-XFP Specifications

42
OK/FAIL LED, one bicolor:
Steady green–The IOC is operating normally.
Red–The IOC has failed and is not operating normally.
Off–The IOC is powered down.
The serial number label is located as shown in
Figure 19: Serial Number Label (IOC Shown, Other Cards Similar)
OK /F AIL
Cards Supported on SRX5400, SRX5600, and SRX5800 Services Gateways on page 29
The SRX5K-4XGE-XFP I/O card (IOC) supports four 10-Gigabit Ethernet ports (see
Figure 20 on page 43). The IOC assembly combines packet forwarding and Ethernet
interfaces on a single board, with four 10-Gbps Packet Forwarding Engines. Each Packet
Forwarding Engine consists of one I-chip for Layer 3 processing and one Layer 2 network
processor. The IOCs interface with the power supplies and Switch Control Boards (SCBs).
You must install at least one IOC in the services gateway. The IOC can be of any of the
available IOC or Flex IOC types.
You can install IOCs in any of the slots that are not reserved for Switch Control Boards
(SCBs). If a slot is not occupied by a card, you must install a blank panel to shield the
empty slot and to allow cooling air to circulate properly through the services gateway.
Figure 19 on page 42.
Serial number
ID label
AA567 8
Copyright © 2017, Juniper Networks, Inc.