SRX5400, SRX5600, and SRX5800 Services Gateway Card Reference
I/O Card SRX5K-4XGE-XFP Specifications
Description
Software release
Cables and connectors
16
The SRX5K-4XGE-XFP I/O card (IOC) supports four 10-Gigabit Ethernet ports (see
Figure 8 on page
16). The IOC assembly combines packet forwarding and Ethernet
interfaces on a single board, with four 10-Gbps Packet Forwarding Engines. Each Packet
Forwarding Engine consists of one I-chip for Layer 3 processing and one Layer 2 network
processor. The IOCs interface with the power supplies and Switch Control Boards (SCBs).
You must install at least one IOC in the services gateway. The IOC can be of any of the
available IOC or Flex IOC types.
You can install IOCs in any of the slots that are not reserved for Switch Control Boards
(SCBs). If a slot is not occupied by a card, you must install a blank panel to shield the
empty slot and to allow cooling air to circulate properly through the services gateway.
Figure 8: IOC SRX5K-4XGE-XFP
OK /FA IL
I/O card with four 10-Gigabit Ethernet XFP ports
Maximum configurable MTU: 9192 bytes
Maximum throughput: 40 Gbps
Junos OS Release 9.2 and later
Four 10-Gbps XFP ports
Supported XFP transceivers:
10GBASE-ER (model numbers SRX-XFP-10GE-ER and SRX-XFP-10GE-ER-ET )
10GBASE-LR (model numbers SRX-XFP-10GE-LR and SRX-XFP-10GE-LR-ET
10GBASE-SR (model numbers SRX-XFP-10GE-SR and SRX-XFP-10GE-SR-ET )
Copyright © 2016, Juniper Networks, Inc.