Display Pcb Replacement; Removing The Display Pcb - Nellcor OxiMax N-600x Service Manual

Display PCB Replacement

Removing the Display PCB

O M N-600x Service Manual
XI AX
WARNING: The LCD panel contains toxic chemicals. Do not ingest
chemicals from a broken LCD panel.
To remove the Display PCB:
1. Turn the monitor off by pressing the ON/STANDBY button.
2. Disconnect the monitor from the AC power source and follow the steps
outlined in Disassembling the Monitor on page 85.
3. Disconnect the Cold Cathode Fluorescent Light (CCFL) harness from J4 of
the Main Board PCB shown in Figure 11 on page 96.
4. Use a small blade screwdriver to remove the clip from either edge of J7, then
disconnect the Display PCB ribbon cable from the connector.
5. Separate the adhesive connection of the double-sided tape and lift the Display
PCB up to remove it from the top case.
Disassembling the Monitor
95