Replacing The Display Pcb - Nellcor OxiMax N-600x Service Manual

Disassembling the Monitor

Replacing the Display PCB

96
6. Remove and discard the used double-sided tape.
Speaker wires to J9
on the Main Board PCB
To replace the Display PCB:
1. Install new double-sided tape as shown in Figure 11 on page 96.
2. Slide the Display PCB into the grooves in the top case.
3. Ensure the Display PCB is firmly seated in the top case.
4. Apply pressure between the top case and the Display PCB to make good
contact with the double-sided tape.
Double-sided tape
Display PCB
Double-sided tape
Display ribbon cable
to J7 on Main Board PCB
Figure 11: Display PCB
Display
ribbon cable
CCFL wires to J4
on the Main Board PCB