Nellcor OxiMax N-600x Service Manual page 37

O M N-600x Service Manual
XI AX
Operation with a Live Subject
Patient monitoring involves connecting the O
qualitative test.
SpO O M
XI AX
2
Sensor Port
LIMITS
To test using a live subject:
1. Ensure the monitor is connected to an AC power source.
2. Connect a DOC-10 pulse oximetry cable to the monitor SpO
port.
3. Connect a Nellcor O
oximetry cable.
4. Clip the MAX-A to the subject as recommended in the O
Directions For Use.
5. Press the ON/STANDBY button to turn the monitor on and verify the monitor
is operating.
6. The monitor should stabilize on the subject's physiological signal in about 15
to 30 seconds. Verify the oxygen saturation and pulse rate values are
reasonable for the subject.
M
XI
O M N-600x
XI AX
100
%SP02
110
BPM
TREND SETUP LIGHT
?
M MAX-A oxygen O
XI AX
Performance Verification
sensor to a live subject for a
AX
O M
2 XI AX
M sensor to the pulse
XI AX
M sensor's
XI AX
sensor
31