Xerox 3050 Service Manual page 752

(Continued)
' 0
STEP 3 A: Insert tKe extractor tabs until
the fete of the tool Is flush with the
connector housing.
3.
(Figure
3):
Remove the Terminals from the
Connectors.
INSERT THE LONG TAB
THROUGH THE WINDOW
B
-
REMOVE TH,E TERMINAL
kOGE OF THE TOOL
IN THE HOUSING
LONG EXTRACTOR TAB
k-.
TERMINAL SHOWN
ROTATED 90"
TERMINAL REMOVAL THROUGH THE HOUSING
SHORT EXTRACTOR TAB
B
-
EDGE OF THE TOOL
0
u
TERMINAL SHOWN
ROTATED 90"
INSERT THE SHORT TAB
THROUGH THE WINDOW IN
THE MODULE CONNECTOR
TERMINAL REMOVAL FROM MODULE CONNECTOR REMOVED FROM THE HOUSING
Figure 3. Remove the Terminals from the Connectors
4/96
Molex Connector Repair Procedure
7-72 3050