Xerox 3050 Service Manual page 480

(Continued)
Replacement
1. Install the Toner Home Sensor.
2. Perform the Toner Home Sensor
Adjustment (ADJ 9.5).
A *
INSTALL THE
0
CARTRIDGE DRIVE
PLATE WITH THE
SJAL
REINSTALL THE
RETAINER
0
STEP3 C : To avoid damage to the drive
Q STEP 3 C: Do not overtighten the screws.
plate seal, always rotate the drive plate
in
the direction shown in Figure 3.
4.
(Figure
4): Reinstall the Top Shield.
3. (Figure 3): Reinstall the Cartridge Drive
Plate.
5. Reinstall the Developer Module.
SCREWS (2) AND
GROUND WIRE
Figure 3. Install the Cartridge Drive Plate
REINSTALL SCREWS REINSTALL THE
TOP
(2)
SHIELD
Flgure 4. Reinstall the Top Shield
REP 9.1 2