Rep - Xerox 3050 Service Manual

5. (Figure 3): Remove the Cleaner blade.
REMOVE THE
CLEANER BLADE
TAR SM4 M
m
Replacement
Q
Applying a coat of zinc stearate to the
cleaning blade before installing the
cleaning blade and retainers will
lubricate them for easier installation of
the retainers.
1. Apply a light coating of
zinc
stearate t o the
cleaning blade.
STEP2 A: With the cleaner housing
positioned as shown, install the cleaner
blade with the arrow pointed up and the
words,. THIS SIDE TOWARD
PHOTORECEPTOR, facing towards you.
Do not touch the edge of the cleaner
blade with your fingers. If the edge is
touched, clean the blade with film
remover and dust again with zinc
s
tearate.
Q STEP 2 B: When installing the cleaner
blade retainers, ensure that the colored
stripe is installed to the outside and
that the holders are completely seated.
2. (Figure 4): lnstall the Cleaning Blade.
BQ
INSTALL THE
CLEANING BLADE
RETAINERS AND
CLEANER BtAD
BOTTOM OF SLOT
Figure 4. Install the Cleaner Blade
Figure 3. Remove the Cleener Blade
(Continued)
3/93
REP 9.4
4-72 3050