Xerox 3050 Service Manual page 642

(Continued)
30. Reinstall the Xerographic Module and the
3 1.
Remove the service rails and reinstall the
perform the following: latch assemblies.
0
STEPS 29 A AND
C :
Ensure that the
a. reconnect all connectors at both ends
photoreceptor is seated completely
of the xerographic module
32. Close the latch assemblies.
down and is secure to avoid movement.
b.
reinstall the fuser drive belt
c. reconnect the idler spring and tighten
33. Rotate the document feed in shelf closed.
29. (Figure 26): Secure the Photoreceptor
the nut
Drum Assembly. d. reinstall the toner waste bottle 34. Reinstall the document handler.
I
LEFT END VlEW
I
ROTATE THE LOCK
BRACKET AND APPLY
PRESSURE WHILE
DOING THE STEP 0
RIGHT END VlEW
p p
- -
- - - -
Figure
26.
Secure the Photoreceptor Drum Assembly
(Continued)
3/93
Installation
6-40 3050