Xerox 3050 Service Manual page 491

REP 10.1B Fuser Heat Rod
2. (Figure 1): Prepare to remove the Heat
(WITaglMODZI)
I
~ ~ d .
Parts List on PI. 10.2
NOTE:
Some copiers are equipped with
M I 0 AC Drive Motors, Developer Drive
Motor (MOT 21), and Fuserl Drum Drive
Motor (MOT22).
RIGHT END VlEW
Copiers equipped with TWO
AC
Drive Motors
are identified as Without Tag / MOD 28, (W I
0
Tag l MOD 28).
Other copiers are equipped with
ONE AC
Drive Motor, Main Drive Motor (MOT21).
Copiers equipped with ONE AC Drive Motor
ere identified
as With
Tag
I MOD 28, (W I
Tag
1
MOD
28).
Use this procedure
on
copiers equipped
with
ONE AC
Drive Motor, (W I Tag I MOD 28),
On copiers equipped with
TWO AC
Drive
Moton, refer to the (REP 10.1A Fuser Heat
Rod (Wl 0 Tag/ MOD 28) removal procedure.
Removal
A
WARNINGS
Switch off the Maln Power Switch
and disconnect the Power Cord.
The Fuser Heat Roll may be HOT I To
prevent burns, allow the Roll to cool
before removing the Xerographic
Module.
B
/
DISCONNECT
1.
Open the Right and Left Side Doors and
THE HEAT ROD
then remove the following:
REMOVE THE
a. Xerographic Module (REP
9.1).
FOAM BEARING
~ 1 5 1 0
b. stripper Finger ~ssembly (REP 10.6).
c. Oil Dispense Assembly (REP 10.7).
I
Rfpe
I.
Prepare to Remoue the Heat ~ o d
I
STEP
3 A and
8: Use
care
when
removing the retainer dip and the
transition gear. The cleaner blade
assembly is spring-loaded
.
I
3. (Figure 2):
Remove the
Transition Gear
and Weight.
LEFT END VlEW
B
LOOSEN SET
R MOVE THE SCREW
A N I I ~ N GEM
-.
I
Flgure 2. Remove the Tranrltion Gear and Weight
4/96
3050
4-IOOA
REP 10.1 B