Irep 9.2A; Assembly (Wl Tag Imod 27); Rep 9.2B Photoreceptor Drum Assembly; Mod27) - Xerox 3050 Service Manual

I
LEFT END VlEW
I
REP 9.2A Photoreceptor Drum
Assembly
(W/ 0 T a d MOD 27)
Parts List on PL 9.2
Note: Some copies are equipped with a
Wing Nut located on the end of the Drum
Shaft. The Wing Nut is identified as Tag/
MOD 27.
Copies equipped with a Wing ~~t
B
ROTATE THE
LOCK BRACKET
.f
LIFT TO REMOVE
Removal
are identified as With Tag / MOD 27, (W I Tag /
MOD27).
Copiers not equipped with a Wing Nut are
1. WARNING1
Disconnect the Power Cord.
identified as Without Tag / MOD 27, (W I 0 Tag
2.
Open the Right and the Left Side Doors.
l
MOD 27),
3.
Remove the Xerographic Module (REP 9.1).
Use this procedure on copiers not equipped
with a Wing Nut, (WIo Tag1 MOD
27).
0 Cover the photoreceptor drum with a
On c0piet-S equipped with a Wing nut, refer to
light shield in order to prevent damage.
the (REP
9.28
Photoreceptor Drum Assembly 4. (Figure 1): Remove the Photoreceptor
Wl Tagl MOD
27)
removal procedure. Drum Assembly.
PHOTORECEPTOR
DRUM ASSEMBLY
-
RIGHT END VlEW
- -
Figure I. Remove the Photoreceptor Drum Assembly
REP 9.2 A